Editing Home Assistant (section)

==Life360==
First, none of this would be possible without the generous work and support by Phil Brukner <br>

[[File:phil.jpg]]<br clear=all>

Thank you, Phil.
----
The most difficult part of the new installation method was discovering my access_token and token_type. <br>
I am HTML-challenged, so after some assistance from Phil, here is how I found the access_token and token_type.<br>

This is done on the Chrome browser.  I couldn't figure it out using Edge. <br>

1. Open Chrome <br>
2. Click on the meatball menu to enable the Developer Tools option. <br>
[[File:Meatball.jpg]]<br clear=all>
<br>
[[File:Developer Tools.jpg]]<br clear=all>
<br>
3. Go to [https://life360.com/login| https://life360.com/login.] <br>
4. Open the browser's Developer Tools sidebar then go to the Network tab. <br>
[[File:Network Tab.jpg]]<br clear=all>
5. Make sure recording is enabled. (CTRL-R)<br>
6. Log into your Life360 account.<br>
7. When the login process has been completed, look for the "token" packet.<br>
Hint- enter "token" into the filter field.<br>
[[File:Find the token.jpg]]<br clear=all>
8. Click on token.json to reveal the access_token and token_type.<br>
[[File:token revealed2.jpg]]<br clear=all>
:Copy those values into the corresponding boxes (access_token and access_type) on the HA account page. (Note that the token_type is almost certainly "Bearer".) You can put whatever you want in the "Account identifier" box.<br>

(If this doesn't reveal your token and type, look for another "token" packet which uses the POST or BEARER method, and has data.)<br>

{{template:top}}